金沙最新登录入口-金沙4399js网站-首页

网站公告:

金沙4399js网站

济南精拓流体设备有限企业

电话:0531-69951198

邮箱:jingtuolt@163.com

传真:0531-69951198

地址:济南市历城区西周南路9号

网址:

业内资讯

当前位置:金沙最新登录入口 - 金沙4399js网站 - 业内资讯 - 气液增压泵的梳理原理先容

气液增压泵的梳理原理先容

发布时间:2021-01-29 14:52:50   发布人:
气液增压泵工作原理类似于压力增压器,对大径空气驱动活塞施加一个很低的压力,当此压力作用于一个小面积活塞上时,产生一个高压。通过一个二位五通气控换向阀,增压泵能够实现连续运行。
The working principle of the gas-liquid booster pump is similar to that of the pressure supercharger. It exerts a very low pressure on the large diameter air driven piston. When the pressure acts on a small area piston, a high pressure is generated. Through a two position five ventilation control directional valve, the booster pump can realize continuous operation.
由单向阀控制的高压柱塞不断的将液体排出,增压泵的出口压力大小与空气驱动压力有关。当驱动部分和输出液体部分之间的压力达到平衡时,增压泵会停止运行,不再消耗空气。当输出压力下降或空气驱动压力增加时,增压泵会自动启动运行,直到再次达到压力平衡后自动停止。
The high pressure plunger controlled by one-way valve continuously discharges the liquid, and the outlet pressure of booster pump is related to the air driving pressure. When the pressure between the driving part and the liquid output part reaches balance, the booster pump will stop running and no longer consume air. When the output pressure decreases or the air driving pressure increases, the booster pump will start and run automatically until it reaches the pressure balance again.
采用单气控非平衡气体分配阀来实现泵的自动往复运动,泵体气驱部分采用铝合金制造。接液部分根据介质不同选用碳钢或不锈钢,泵的全套密封件均为进口优质产品,从而保证了气液增压泵的性能。
气液增压泵
The single gas control non-equilibrium gas distribution valve is used to realize the automatic reciprocating motion of the pump, and the gas drive part of the pump body is made of aluminum alloy. Carbon steel or stainless steel is selected according to different media for the liquid receiving part. The whole set of seals of the pump are imported high-quality products, so as to ensure the performance of the gas-liquid booster pump.
1、输出压力高,输出压力可高达400Mpa。
1. High output pressure, up to 400MPa.
2、使用范围广,工作介质可为液压油、水及大部分化学腐蚀性(相应的耐腐蚀材质密封)液体,并且可靠性高,免维护和寿命长。
2. Wide range of use, working medium can be hydraulic oil, water and most of the chemical corrosive (corresponding corrosion-resistant material seal) liquid, and high reliability, maintenance free and long service life.
3、易于调节,在泵的压力范围内,调节调压阀从而调节输入气压,输出液压相应得到无级调整。
3. It is easy to adjust. Within the pressure range of the pump, adjust the pressure regulating valve to adjust the input air pressure and the output hydraulic pressure.
4、自动保压,无论何种原因造成保压回路压力下降,泵将自动启动,补充泄漏压力,保持回路压力稳定。
4. Automatic pressure maintaining: no matter what causes the pressure drop of pressure maintaining circuit, the pump will start automatically to supplement the leakage pressure and keep the circuit pressure stable.
5、操作安全,采用气体驱动,无电弧及火花,可在危险场所使用。
5. Safe operation, gas driven, no arc and spark, can be used in dangerous places.

13188935873

qq

金沙最新登录入口|金沙4399js网站

XML 地图 | Sitemap 地图